Bolens 247.77763 - Manual (Page 5)

ASSEMBLY
with Support Bracket
r-j
20-oz. Bottle
of Engine Oil
Figure 1
IMPORTANT: This unit is shipped without gasoline
or oil in the engine. After assembly, see
OPERATION section of this manual for proper fuel
and engine oil fill-up.
NOTE: To determine right and left hand sides of your
chipper-shredder vacuum, stand behind the unit with
the engine farthest away from you.
Your chipper-shredder vacuum has been completely
assembled at the factory, except for the nozzle, the
chipper chute with support bracket and the catcher bag.
These parts are shipped loose in the carton. A pair of
safety glasses and a 20-oz. bottle of engine oil are also
included in the carton.
Removing From Carton
• Cut the corners of the carton.
• Remove all packing inserts.
• Remove ail loose parts. See Figure 1.
• Push down on handle to lift front of chipper-
shredder vacuum and roll unit out of the carton.
• Make certain all parts and literature have been
removed before the carton is discarded.
Loose Parts
(See Figure 1.)
1.
Nozzle
2. Chipper Chute with Support Bracket
3. Catcher Bag
4. Safety Glasses (Not Shown in Figure 1 )
5. A 20-oz. Bottle of Engine Oil
Tools Required
1. 1 /2" or adjustable wrenches
2. 7/16” or adjustable wrenches
3. Funnel (Recommended)
4. Pliers
Disconnecting Spark Plug
(See Figure 2.)
•
Before proceeding with assembly of your new
chipper-shredder vacuum unit, disconnect the
spark plug wire from the spark plug on the
engine and move it away. This will prevent
accidental starting of the engine in any way.