Attaching the nozzle, Attaching the chipper chute – Bolens 247.77763 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Attaching the Nozzle
(See Figure 3.)
•
Remove the three plastic wing nuts from the
front of the chipper-shredder vacuum.
•
Place the nozzle over the three weld studs.
•
Secure with the plastic wing nuts just removed.
Plastic
Wing Nuts
Attaching the Chipper Chute
• Loosen, but do NOT remove, the two hex bolts,
flat washers, and flange nuts which are secured
to the support bracket. See Figure 5.
Figure 5
Remove the two flange nuts, hex bolts and
saddle washers which secure the right side of
the upper handle to the right side of the lower
handle. See Figure 6.
Next, remove the three hex nuts and bell
washers from the weld studs found beside the
opening on the right side of the chipper-shredder
vacuum. See Figure 6.
NOTE:
The metal tab in the nozzle must depress the
safety switch on the front of the chipper-shredder
vacuum or the engine will not start. See Figure 4.