Using the battery pack, Ir# |£jr3 g l 3, Installing the battery – Bell Sports BAM-300D User Manual
Page 8: Removing the battery, Battery charge level
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
HI
# Using the Battery Pack
Fully charge the battery before the first use of the
phone.
The phone comes with a rechargeable battery pack. The
battery pack is not fully charged so one must charge it
immediately after purchasing the phone. Keep the battery
charged when not in use in order to maximize talk time
and standby time when using the phone remotely.
Installing the Battery
The Battery pack is keyed so it can only fit one way.
1. Align the groove in the battery pack with the rail on
the back of the phone until the battery pack rests
flush with the back of the phone.
2. Slide the battery pack forward until it clicks. This
locks the battery in place.
Rail
Groove
j
S*
Removing the Battery
1. Turn the power off. (If power is not off, a loss of
stored numbers and messages may occur.)
2. Push and hold down the battery release latch on the
back of the phone and slide the battery down and
out.
I
1
n
1
^
¡T
I
i
I
I i
1
1
I
I
'
\
^ I
m
^
L
j
>5*
Battery Charge level
Yiiiil ®
cy
The battery charge level is shown at the top right of
the LCD screen on the phone.
Ir# |£jr3 g L 3
When the battery charge level
becomes low, the low battery
sensor will alert you in three
ways: sounding an audible tone,
flickering the battery icon and
displaying
“LOW
BATTERY
WARNING”. If the battery level
becomes too low, the phone will
automatically switch off and any
function in progress will not be
saved.
LOUl BRHERV
liJRRNING!
-UJRRNING-
LOUJ BRHERV
Turning OFF!
LT
14