ClearSounds CST25 - Manual (Page 9)

Page 6
Wall Mounting
1. Turn the phone over so that you are looking at the bottom of the phone. Insert tabs at
the thin end of the wall mount bracket into the holes at the
rear of the phone bottom. Press and latch the tabs at the
thicker end of the wall bracket into holes at the front end of
phone. The back of the phone should then have two round
plastic holes that can be used to hang your phone on the
wall.
2. Use the two round holes to hang the phone on the wall plate on your wall.
Important Note
: If you do not wish to mount your phone on the wall, the Wall Mount
Bracket can be reversed to raise the angle of the phone's display when sitting on a table
or desk.
Adjusting the Display Angle
You can optimize the LCD display by adjusting the viewing angle. To adjust the LCD
viewing angle, move the rear edge of the LCD module up or down.
Adjusting the Display Contrast
The display can be adjusted to suit the light level of your room and your viewing
preference. To make the contrast of the display lighter or darker, press the
◑ button to
the right of the screen until the desired contrast is reached.
Adjusting Handset Receiver Volume
To adjust the handset receiver volume:
1. Lift the handset and listen to the dial tone.
2. Press
the Volume up button to increase the receiver volume.
3. Press the Volume down button to decrease the receiver volume.
4. Replace the handset when the desired receiver volume is reached.