Setting the clock, Setting the timer, To display the current time – Aiwa CX-NA71 User Manual
Page 22: To switch to thé 24-hour standard, Preparation, Setting the clock setting the timer
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
I
SETTING THE CLOCK
SETTING THE TIMER
1
Press the CLOCK button on the remote control,
and press the II SET button within 4 seconds.
2
Press the ◄◄ DOWN or ►► UP button to
designate the hour, and press the II SET button.
The hour stops flashing and the minute starts flashing.
3
Press the ◄◄ DOWN or ►► UP button to
designate the minute, and press the II SET
button.
The minute stops flashing on the display and the clock starts
from 00 seconds.
'
To display the current time
Press the CLOCK button on the remote control. The time is
displayed for 4 seconds.
However, the time cannot be displayed during recording.
To switch to thé 24-hour standard .
Press the CLOCK button on the remote control and then press
the ■ button within 4 seconds.
Repeat the same procedure to restore the 12-hour standard.
If the clock display flashes
This is caused by a power Interruption: The current time needs
to be reset.
If power is interrupted for more than approximately 24 hours,
all settings stored in memory after purchase need to be reset.
3
1,2
The unit can be turned on at a specified time every day with the
built-in timer.
Preparation
Make sure the clock is set correctly.
Use the remote control.
1
Press the TIMER button once to display ©, and
press the II SET button within 4 seconds.
© is displayed, and the hour flashes.
If you press the
II
SET button after 4 seconds, another
operation may start.
2
Designate the hour of the timer-on time by
pressing
the
DOWN
or
UP
button,
and
press the 11 SET button. Repeat to designate the
minute of the timer-on time.
After you designate the timer^on time, one of the source name
flashes on the display for 4 seconds.
3 Within 4 seconds, press one of the function
buttons to select a source.
The selected source name flashes for 4 seconds. At this time,
the selected function button does not light up.
• If this step is not completed within 4 seconds, repeat from
step 1.
• If the TUNER button is pressed, the band cannot be selected
in this step.
4
Within 4 seconds, select the duration for the
timer-activated period with the M-^i DOWN or
UP button.
21
ENGLISH