Audiovox CTX5000 - Manual (Page 11)

To Recall from Memory with Name
Recalling from the repertory memory is identical to
standard repertory recall. When the number is
recalled, the display will show the Alpha Name Tag
as well as the stored phone number.
ALPHA SEARCH
This feature permits you to find a phone number
stored in the memory by the first character of the
Alpha Name Tag. This search can retrieve all
entries beginning with the assinged initial letter.
1- Press \ FUNG |, then | VOL | to set the Alpha Mode.
2, Enter the initial letter, by which you wish to
search the phone number. Then press | V0L| .
The display will show 3. Press [R^, then P v O l I
the first entry whose Name Tag begins with the
assigned initial letter, and which is stored in the
lowest memory address. Display shows Name
Tag, Memory Address and Phone Number.
4. Press [ttlor [¥|.
rSj: Scroll memory address upward.
Rl: Scroll memory address downward.
Example;
Operation
I
FUNG
I I
VOL]
[5] rVOL]
Display
RCL VOL
A 1 P
h
a
C _L
J
—
1
J 0 H N
(T I'P
4 | 5 l 6 7 8 9 0
J A
c
K t
0 5 ~ 7 | 6 5 4 3 2 1 1
J
A m I e S
1 5 - 9 | 8 7 6 ^ ¡ 5 | 4 3
i
[1 J I M
9 9 “ 8 | 7 6 5 4 3 2
J 0 H N
0 ) l - 4 | 5 6 7 8 9 0
J I M
[ 9 9 | - 8 ( 7 6 5 4 3 2
PLACING TELEPHONE
CALLS
To Place a Call
1. Enter the telephone number with the Handheld
on or off the Booster. The last 15 digits of
the dialed number are displayed on the readout.
Note: After 120 sec., display will return to the 10
digit display mode.
2. If a dialing error is made, press | C L R |, then
enter the telephone number again. Pressing
1
C L R |
momentarily (less than approx. 0.5 sec.) clears the
last digit.
3. Press I S N P I. The | I N U S E | indicator will light.
You may lift the Handheld from the Booster
before or after called party answers to proceed
with your conversation.
Note; If assigned in NAM, the telephone number
can be pre-set up to 32 digits. However, in
this case, it is necessary to confirm with
system operator whether such service is
available or not.
If the Call Fails to Go Through
1. I f you hear the “reorder” signal, press | E N D | ,
then if there were no dialing errors, press | SND|
for redial.(Digit key re-dialing is not necessary.)
2. If the “intercept” signal is heard, hang up, then
redial the correct number.
Automatic Redial(NAM OPTION)
If selected, your unit will automatically make five
attempts to reach the cell site when the first try is
not successful. The |
IN USE | indicator will stay on,
but the speaker will be muted for twenty seconds.
This is done so you to do not hear the reorder
signals out of the speaker. If you wish to terminate
the automatic redial, press [ i ENDI .
Termnating a Call (Hanging Up)
20
Press I END ), or replace the Handheld in the
Booster. The
1
IN USE | indicator will go out.
If Hands-free is activated in NAM, you have to
press I END | key to terminate a call.
21