Audiovox CTX5000 - Manual (Page 15)

If you want to confirm the current mode, press
I FUNC I , key then . Status indicator shows
the Current mode. To return the unit to the
standard mode, press [ f UNC] key then
again. Status indicator shows STD 1. The unit
will scan the preferred system channels. If unable
to find an acceptable preferred channel, the unit
switches to scan the non-preferred channels.
2. Preferred System Only Mode
Press I RJNC I , key then Q], Status indicator
shows 1 PRF I . The unit will scan the preferred
system only and prevents switching over to the
non-preferred system,
3. Non-preferred System Only Mode
Press I FUNC |, key then . Status indicator
shows 1 N-PRF j. The unit will scan the
non-preferred system only,
4. Home Only Mode
Press pFUNC |, key then [ 2]. Status indicator
shows I Homel . You can place or receive calls
only within your home area.
Note: (1) The [ ROAM | indicator lights as follows.
Lights continuously;
When the unit in the preferred
system in another city.
Flashes; When the unit is in the
non-preferred system.
(2) The 1 NO SVCl indicator flashes when the
mobile unit is requesting service but not
in the requested service area.
SYSTEM INHIBIT
(NAM OPTION)
This feature permits you to select (by NAM Option),
any interfering system, or Roam System you do not
want to use, even when in that service area.
[ no SVCl indicator flashes, if your A / B switch is
selected to any system that is inhibited.
RADIO FREQUENCY (RF)
CHANNEL INDICATOR
L Press [RCL I, key then , The RF channel
number in which your unit is operating will be
displayed on the top line of the readout. RSSI
(decimal format) and SAT frequency will be
displayed on the bottom line. The display format
is as follows;
C 1 2 3
|R 1 8 7 S 6 0 3 0
C123...... RF channel Number
R187...... RSSI value
S6030-'-- SAT Frequency
2. When on a call, the display will update when a
handoff occurs.
3. The display will remain in the display until you
manually reset it by pressing any key.
CALL IN ABSENCE
INDICATOR
(when Handset is using Booster)
This feature indicates to you that a call came in while
you were out of your car.
1, Before leaving the car, with the ignition switch on,
press [FUNC I, t h e n . The display shows | Call].
Turn off the ignition switch, but leave the car
tel phone power switch ON. If necessary, lock the
unit.
2, When a call is received, the unit indicates it by
flashing the [CALL | display on the readout.
3. This mode is deactivated:
1) When the ignition switch is again turned to “on”
or “accessory".
2) After 8 hours, or
3) By pressing I FUhTc I, then again.
4. The 1 CAL l I indication will remain in the display
until you manually reset it by pressing any key in
the Handheld Portable Unit or by lifting it from the
Booster Unit.
Note: The 8 hour timer can be changed with the
Safety Timer feature.
If necessary, you can see the RF channel number in
which your unit is operating.
28 29