Black & Decker SR650 - Manual (Page 11)

HINT; To best see the flats and your wrench, remove the table insert
and view through the top of the table. Reinstall table insert before use.
Starting Pin
A starting pin is supplied with your Shaper/Router and is used to
support the workpiece ot the start of the cut when using the
Shaper/Router without the fence. Install the starting pin as shown in
Figure 18. Make sure auxiliary guard is in place furore use.
Installing the Shaper Spindle and Shaper Cutter (Figure 19)
An accessory 1 /2" (12.7mrh) shaper cutter spindle that
accommodates 1 /2" (12.7mmj bore shaper cutters is supplied for
use with your Shaper/Router and can be installed as follows:
1. MAKE CERTAIN THE MACHINE IS DISCONNECTED FROM THE
POWER SOURCE.
2. Raise tool spindle as far as it will go and lock the cutting
depth handle.
3. Select shaper spindle and shaper spindle nut. Thread shaper
spindle into small diameter threads in shaper spindle nut.
4. Screw shaper spindle into shaper spindle nut until the shaper
spindle shoulder protrudes approximately 1 /16" (1.6mm) above
the face of the shaper spindle nut, as shown in Fig. 19B. Maintain
this position as you install the shaper spindle to the tool spindle.
5. Insert tapered end of shaper spindle into tapered end of
tool spindle.
6. Tighten the nut securely to tool spindle using the same means you
used for tightening the collet nut.
7. Install the desired cutter. The cutter must have a 1 /2“ (12.7mm)
hole or bushings (supplied by cutter manufacturer) to reduce the
hole to 1/2" (12.7mm). When installing the shaper cutter use the
appropriate combination of supplied spacers to raise or lower the
shaper cutter. Use the appropriate collar for your cutter when
shaping without the fence. The cutting depth handle can also be
used to adjust the height.
For detailed instructions on cutter Installation, refer to instructions
provided by cutter manufacturer.
piu
0