Black & Decker SR650 - Manual (Page 7)

Shaper
ASSEMBUNG AND INSTALUNG THE FENCE
A cardbtxird box inside the tool carton contains the larger fence
parts. The hardware required for assembly is in two (2) plastic bags in
the cardboard box.
Select, from the cardboard box, the center yoke, the two wooden
fence boards and the fence bracket shown in Figure 1. Loosely install
the fence bracket, as shown in Figure 2, using one of the 23mm
(0.9") knobs and 6mm flat washers from the plastic bag. Use the four
hothead screws, 6mm washers and hex nuts from the plastic bag to
loosely install the wooden fence boards to the center yoke and the
fence bracket, as shown in Figure 3.
Using two 30mm (1.2") plastic knobs and (2) 8mm (0.32") Rat
washers from the plastic bag, install the fence to the table top, as
shown in Figure 4. Thread these knobs into the two threaded holes
closest to the rear of the-table. (The third threaded hole closer to the
front of the table is for the starting pin which will be discussed later.
Do not install it at this time.)
Use a straightedge to make the two wooden boards even with each
other and hold that position while you firmly tighten the four screws
and the plastic fence bracket knob, as shown in Figure 5. Move the
completed fence as necessary to make it roughly parallel to the rear
edge of the table fop. Securely tighten the two knobs to hold the
fence stationary.
Figure 6 illustrates clear plastic guard assembly. Insert the guard bar
into the guard holder on the rear position of the fence center yoke, and
install a 23mm (0.9") plastic knob into the side of the guard holder to
securely hold the guard in place, as shown in Figure 7.
Assembling Table Insert
The table insert is placed in the table, as shown in Figure 8.
Bench Mounting (See Figure on Following Page)
TURN OFF AND UNPLUG SHAPER/ROUTER.
The shaper/router must be mounted firmly to your workbench or other
anchored frame. Four holes are provided in the tool's feet for this
CEHTER
YOKE
immFIAT
WASHERS
HEX NUTS
FENG
luaEi
WOODEN FENCE
BOARDS