Beko DVG 695 - Manual (Page 13)

Grill Burner
The conversion must only he implemented hy a
qualified engineer.
1. Replace the gas orifices by the NG or LPG
equivalents.
2 . Check gas soundness.
3. Remove the control knobs.
4. Adjust the reduced rate of the burner.
c. Grill burner
• Take out burner plate
• After taking out burner plate, identify
the gas feeding tube of grill
• Remove the injector elbow fitting from
spring clip
• Turn the grill pipe clockwise and remove
the injector elbow.
prepqmtion and burning off
h i
Important for asthmatic sufferers
Before using for the first time, protective
coatings need to be burnt off. Fumes will be
emitted but this is quite normal.
Ensure the room is very well ventilated
during the burning off process. Avoid directly
inhaling the fumes during this process.
Grill
Open the grill door. Remove grill tray, wire
rack and detachable handle and operate the
grill for about 15 minutes.
Oven
Remove baking tray and shelf racks and
operate the oven at gas mark 7 for 30 minutes.
Cleaning
Before you start using your cooker, clean
the appliance as recommended under Care
and cleaning on page 22.
The shelf rack with a heat deflection sheet
should be positioned in the lower shelf position
in the main oven.
Oven burner heat shield positioning
Before you start using your cooker please ensure
the main oven burner heatshield is positioned
as shown.
Oven heatshield —
To locate press in the direction indicated above.
• Fit the appriate injector by using a suitable
tool
13 14