Country Home Products Men's Trimmer - Manual (Page 24)

20 DR ® TRIMMER/MOWER ™ Safety & Operating Instructions
Figure 14
Figure 15
Adjusting the Cutting Height
Adjusting the cutting height is easy. Cutting heights range, in ½ inch increments, from 1½
inches when using the bottom line plate, to approximately 4 inches when using the top line
plate
(Figure 14).
1. Install the cutting cords in the line
plate that gives you the desired
cutting height.
The Mow Ball  Support
Allow the front end of the machine
to rest lightly on the Mow-Ball

Support as you are trimming. The
Mow-Ball
™ Support should glide on
the ground as you maneuver the
machine. To achieve the best and
smoothest cut, do not lift up on the
handlebar while operating your
DR
 TRIMMER/ MOWER ™ . Lifting
the handlebar will force weight
down on the Mow-Ball
 Support.
This uses more energy, slows
down the cutting, and produces an
unsatisfactory cut. Ideally, the
Mow-Ball
 Support should lightly
rest on the ground while the
wheels balance most of the weight
of the machine (Figure 15).
Important!
When using the PTA  feature, install the cutting cords in one of
the four bottom line plates only.