Installation – AEG 302D User Manual

Page 13

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Installation

Before fixing the furniture door to the hood, please ensure the

correct distance between the plate and the upper edge of the
cabinet door (depends on the thickness of the material and
whether or not there is an upper shelf) (Fig. 6).

1. Remove the grille filter

C

by turning the locks

D

and pull it out

downwards (Fig. 3).

2. Take off the extendable vapour guide G (fig. 7) by turning the

rear locking knobs

H

(Fig. 7).

3. Draw a line with a pencil on the middle of the internal side of the

furnituture door (Fig. 8).

4.

Fit the plate upon the internal side of the furniture door so that

the line previously marked on it, is visible through the two
triangles holes located on the mid upper and lower side of the

plate, having care to respect the distance from the plate to the
higher edge of the furniture door as for the reason mentioned

above.

5. Fasten the plate to the furniture door through the 6 screws

L

4,5

X 13 mm supplied (Fig. 8).

6. Replace the complete fume protection plate assembly into the

extractor hood, first inserting it on its upper, then on its lower
guides.

7.

Turn the rear unlocking knobs H (Fig. 7) so to avoid the fume

protection plate take off.

8. Replace the grille filter.

1. Remove the grille filter (Fig. 3).

2. Remove the fume protection plate (Fig. 7).
3. Mount the two hanging rails directly underneath the edge of the

cupboard using three screws 4,5 x 16 mm each rail.

Distance from first hole to front edge of the cupboards sides
must be 153 mm (Fig. 9).

4.

Push the extractor hood over the two hanging rails, then fix the

hood from its inside to the cupboards sides with two screws (4,5

X 13) through the lower holes of the hood (Fig. 10).

5. Replace the the complete fume protection plate assembly into

the extractor hood.

6. Replace the grille filter. •

7.

Ensure that there is not a gap between the back of the hood and

the wall by adjusting the spacer M tightly to the wall, using the

screws O (fig. 12).

Fixing the

furniture

door to the
hood

Installing the
hood between
cupboards with
hanging rails

13

Advertising