Audiovox Prestige PR-140 - Manual (Page 12)

Silent Incoming Calls
If Silent Alert feature is set, a single beep and a flashing
IL IHIL im message on the display will alert you of an
incoming call.
Once you have switched to silent alert, the phone stays
in that mode until you deactivate it.
1. Press @, then (©. The 151 - fWlTli: I fiTTnl will
appear in the display will alert you.
2. When you receive a call, a single beep and a flashing
InWnrLl message on the display.
3. Press ( send ) to answer the call.
ICIRII t fn on the readout will go out.
4. This mode is deactivated by pressing @, then (^.
mpli^fl ll 11 1
0
1 f I will be displayed for 5 seconds.
5. If the Silent Incoming Calls is activated when the
unit is powered up, [5l-|i-l|Lli:l lofiTI will appear
on the readout for 5 seconds.
Any Digit Key Answering
(NAM Option)
This feature permits you to answer an incoming call by
pressing any of the digit keys on the key pad.
Automatic Answering
With this feature, the incoming call will be automatically
connected for operation after two alert tones, and the
IIN USEl indicator will light on the readout.
Then the unit is ready for conversation.
To activate this mode, press @ and then key (©.
I I -1BI n151 IQ1
1
^ will appear on the readout.
This mode is deactivated when @ and then key (§)
are pressed again.
I P i I 'T^rnTSl I o fFl will be displayed for 5 seconds.
This feature will not function if the unit is in the
Lock and Silent Incoming Calls.
If the Automatic Answering is activated when the
unit is powered up, I B I - l f l l o l S I l o f n i will appear
on the readout for 5 seconds.
2 .
3.
To Place a Call with a Number in the
Memory
1. Press @, (©, then enter the memory address (01
through 30). The last 8 digits of the number will
appear on the readout. If the number is longer than
8 digits, hold down the second digit of the memory
address (after pressing @, (©) to see the prefix.
Note; See “To Recall a Number from Memory” and
“To Review the Prefix” for more details.
2. Press ( send ). The IlN USEl indicator will light as the call
is placed.
Speed Dialing
This feature permits you to place a call from the stored
memory locations without using the recall @, (© key.
Speed dialing is a quick method of placing calls from
memory.
1. Enter the one or two digits of memory address (1
through 9 and 10 through 30).
2. Press ( send ). The last 8 digits of the phone number
will appear on the readout, and the IlN USEl indicator
will light.
Last Number Redial
This feature permits you to redial any of the last phone
numbers you attempted to call.
Numbers will be stored in memory only if
( send ) key
is pressed.
1. Press @, © then (§[).
2. Press ( sb ^ to send a displayed number.
Note: To clear the stored number, press @, (^HP). then
(si®)
21 22