End-to-end signaling, Scratch-pad dialing, Scratch-pad dialing without keying tones – Audiovox Prestige PR-140 User Manual
Page 14: To display the talk time, Outgoing call timer only (nam option), To clear the timer, Scratch pad dialing, End-to-end signaling call time display
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
END-TO-END SIGNALING
CALL TIME DISPLAY
This feature permits you to utilize additional phone
services, such as accessing an alternate long distance
network, signaling pager, or banking by phone etc..
For these services the signaling should be in DTMF
(Touch Tone™).
SCRATCH-PAD DIALING
This feature permits you to enter a number to be redialed
(or store a number in memory) while engaged in a
conversation.
SCRATCH-PAD DIALING
WITHOUT KEYING
TONES
This feature permits you to activate scratch-pad memory
without annoying key tones over the circuit.
1. Press then key (^ , then enter a phone number.
fFI o 1 n
mi
To
I
f I ~l will be displayed for 5 seconds.
The Microphone circuit will remain active, but the
tones will not be heard.
2. If necessary, press ®, (£) , then enter the memory
address.
3. To exit the Scratch-pad Mode, press (®), then key
(© again.
I ■- IQI
n
in
I
o
I
i-i
I
I
will be displayed for 5 seconds.
This feature automatically records the elapsed time per
conversation. The talk time of the last call and cumula
tive talk time, can be displayed on the readout. The
timers can also be cleared if necessary.
To Display the Talk Time
1. Press then key ©.
2. While the key (© is held down, the cumulative talk
time will be displayed on the readout in minute
format.
I i161 'I ... 18 min.
3. The talk time of the last call will be displayed on the
readout for 5 seconds after the (© is released.
While in a conversation, the talk time of a call in
progress will be displayed. The display format is as
follows.___
I '(31 ' FT?151 ... 1 min. and 25 sec.
Outgoing Call Timer Only
(NAM Option)
Normal call timer operation is to time both the calls
made and the calls received. If the “outgoing call timer
only” function is activated (NAM Option), the call timer
will only amount of time when placing calls. It will not
amount of time for calls received.
To Clear the Timer
1. Press (§),
then enter the three-digit security
code.
2. Press @, key © then (©, ©. l O l O l G I f W ^ will be
displayed for 5 seconds.
The timers will be cleared, and the count for the
cumulative talk time will start from zero.
25
26