Safety features, Hood switch, Istrostart – AstroStart 3106M User Manual

Page 20: Safety checks

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

¡SAFETY CHECKS

In order to maintain a high safety standard, proceed with the following checks every month.

SAFETY FEATURES

Make sure the parking brake is operational, i.e. it has the capability of

immobilizing

the vehicle.

If the parking brake cannot stop the wheels from turning, which is not safe, place the main switch in ”

OFF

position until the situation is rectified

.

D

etection

of

parking

brake

status

Carry out the safety sequence, then remote start the engine to confirm the safety sequence is valid.

Make sure not to apply the brakes.

Release the parking brake.

The engine must stop immediately upon releasing the parking brake. If the engine does not stop, which is

not safe, place the main switch in ”

OFF

position until the situation is rectified

. Consult your service

center.

D

etection

of

door

opening

Make sure that the opening of

each

door (open one by one) will break safety sequence.

1. Carry out the safety sequence, then remote start the engine to confirm the safety sequence is

valid.

2.

3.

4.

Stop the engine using the remote control. Make sure you do not apply the brakes and that the

parking brake remains applied until step 4.

Open then close

only one door

once the engine has stopped.

Try to start the engine using the remote control.

The engine should not be able to be remote started and the system should generate error code #15.

Repeat this test

for every door

of the vehicle (

including hatchback

if applicable). If the vehicle is

equipped with fold-down rear seat backrests, the trunk has to be considered as a door since it is an

opening that can give access to the passenger compartment. It

must

therefore be included in the safety

sequence.

If the engine starts, which is not safe, place the main switch in ”

OFF

position until the situation is

rectified.

Consult your service center.

HOOD SWITCH

Remote start your vehicle then open the hood.

Engine should stop as soon as hood is opened. If engine does not stop immediately, turn main switch to

OFF

position

and leave it off until situation is rectified.

Contact your service center.

[

replacing

_

orboostingvehiclebatter

^^^_^^J

If you have to replace or boost your battery for any reason, turn main switch to

OFF

position

and leave it

OFF until battery is replaced or fully charged.

R

eversing

polarity

when

boosting

your

battery

could

permanently

damage

your

remote

starter

.

Note

: If alarm is armed when battery is disconnected, siren will sound when battery is reconnected if a

zone is in violation.

To avoid this, put system in Valet Mode before disconnecting battery.

18

/IstroStart

Advertising