Affixing distance markers to the monitor screen, Vom-78t operations manual – ASA Electronics Voyager VOM78T User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
VOM-78T OPERATIONS MANUAL
AFFIXING DISTANCE MARKERS TO THE MONITOR SCREEN
1. Clean monitor screen surface of fingerprints. Place distance indicators behind the vehicle at (3) feet, (5) feet and
(9) feet along the width of the vehicle.
These distances are measured from the rear bumper.(Refer to fig. 5)
2. Attach the markers to the monitor screen over the images of the distance indicators.
These markers represent distances of (3) feet, (6) feet and (9) feet from the back of the vehicle (See fig.5)
3. Affix the "STOP" marker on the monitor screen over the image of the rear bumper to locate the rear bumper.
4. The monitor screen is now "calibrated" for distances behind the vehicle of (3) feet, (6) feet and (9) feet.
DASH BOARD
OR OVERHEAD
STEEL PLATE FOR REINFORCEMENT
(RECOMMENDED FOR SECURE MOUNTING)
FIGURE 1
VOM-78T 7