Setting prewash, Washing clothes manually, Using delay start – Avanti W1092F User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
• Choose the Fabrics program to the type of clothes you are washing: Cotton, Perm Press, Délicates, KnrtAVool.
You will see the indicators light up on the control panel.
• At this time, you can control the water temperature of wash and rinse by .pressing the WASH/RINSE
Temperature button.
•
Press the Starf'Pause button and the wash cycle will begin.
If you want to pause, press
the Start/Pause button again.
When The Cycle Is Finished:
When 10 minutes passed after total cycle is finished, then power will turn off automatically.
• Press the Power button
• Open the door and remove the laundry.
> Setting Prewash
Prewash is only available when washing Cotton, Perm Press or Delicate dothes.
To use prewash.
• Load 1-1/2 times the amount of detergent into compartment II of the detergent drawer.
• Select the wash program (Cotton, Perm Press or Délicates).
• Press the Cycle button until the “Prewash" indicator lights up on the control panel.
• Press Start'Pause to begin the cycle.
> Washing Clothes Manually
You can wash clothes manually without using the fuzzy logic feature.
To do so:
• Turn on the water at the water source.
• Press the PowST button on the washing machine.
• Open the door and put the laundry into the washer.
• Put the detergent and. if necessary, softener or chlorine bleach in the appropriate compartments.
• Press the WASH/RINSE Temperature button to select the water temperature.
• Press the Extra Rinse button to select the Extra Rinse feature.
• Repeatedly press the Cycle button to select the'cycle you
prefer,
• Press the Start'Pause bution and the machine will begin the cycle.
iYhen the cycle is finished:
• Press the Power button.
• Open the door and remove the laundry.
Note: The door will not open until 3 minutes after the machine stops or the power turns off.
The Door Locked indicator lights whenever the door of the washer is locked and unable to open.
- Using Delay Start
You can set the washing machine to start your wash from 1 to a 24 hours delay. To do this:
• Manually or automatically set your washing machine for the type of clothes you are washing.
• Press the Delay Start button repeatedly until the delay time is set.
• Press the Stari'Pause button. The delay start indicator wiii light, and the dock will begin counting down
until it reaches your start lime. (In hour increments)
• To cancel Delay Start, press the Power button, then turn the washing machíne on again.