Cleaning the debris filter, Cleaning the water hose mesh filter – Avanti W1092F User Manual
Page 14
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Cleaning The Debris Filter
Clean the debris filter 2 or 3 times a year.
• Remove the base cover from the front of the washing machine.
• There may be water remaining in the tub overflow. Unplug the
discharge hose to eliminate any excess
water. Be sure to place a pan under the hose to prevent water from spilling on your floor.
• After the water has been drained plug the discharge hose and put It back it into its place.
• Unscrew the filter cap and take it out.
• Wash any dirt or other material from the filter. Make sure the drain pump propeller behind the filter is not
blocked. Replace the filter cap.
• Replace the base cover.
i t
3
:=
> Cleaning The Water Hose Mesh Filter
You should clean the water hose mesh filter once per year, or when you see the following error message
on the display:
To do this:
_
• Turn off the water source to the washing machine.
• Unscrew the hose from the back of the washing machine.
• With a pair of pliers, gently pul! out the mesh fitter from the end of the hose and rinse it un^er water until
clean. Also dean the inside and outside of the threaded connector.
• Push the filter back into place.
• Screw the hose back onto the washing machine.
• Turn on the faucet and make sure the connections are watertight.