To light the desired surface burner, Operating your oven burner, Wariffl^g – Avanti GR-24BG User Manual
Page 11: Before lighting a burner
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
> To Light the Desired Surface Burner
• Push the control knob in.
•
After the burner ignites, turn the knob counter-clockwise without releasing it to adjust the
flame size. Then release the knob.
•
For maximum heat output, align the large flame symbol on the knob with the vertical line
on the control panel. In order to decrease the heat output, turn the knob in the direction of
the small flame symbol. For minimum heat output, align the small flame symbol on the
knob with the vertical line on the control panel.
•
The amount of food being cooked, the amount of liquid, or the size of the pan should
determine
the
heat
settings.
Always
position
the
utensil
on
the
burner
grate
before
lighting the burner. For your safety, the flame should not extend beyond the sides of the
pan. Any flame larger than the bottom of the cookware is wasted and only heats the
handle.
• To turn the burner off, turn the knob clockwise until it reaches the {•) symbol.
• Before lighting a burner.
• Make sure all grates on the range are In place before using any burner.
•
After the burner ignites, turn the knob to adjust the flame size. Watch the flame not the
knob, as you adjust the heat.
• In case of power failure.
•
You can light the surface burners on your range with a match. Hold a lighted match to
the burner, and then turn the knob to the ON position.
Use extreme caution when
lighting burners in this manner.
•
Surface burners in use when an electrical power failure occurs will continue to operate
normally.
NOTE; The electrode of the spark igniter is exposed. When one burner is turned to ON, all the
burners spark. Do not disassemble or clean around any burner while another burner is on. An
electric shock may result, which could cause you to knock over hot cookware.
Operating Your Oven Burner
•
The oven is controlled by a knob located at left side of control panel.
(See Figures 9 & 10)
•
This knob has two functions.
■
To control oven burner.
■
To control broiling burner.
•
When the knob is turned in a counterclockwise direction, it controls the oven. When the
knob is turned in the clockwise direction, the broiler is engaged. Those burners do not
run simultaneously.
•
The oven burner is controlled by a thermostat and has a flame failure device. The
numbers on the knob indicate the temperature in the center of oven cavity in degrees of
Fahrenheit.
—A
WARiffl^G^
The maximum amount of weight placed on to the oven shelf must not exceed 30 lbs.
11