Care and maintenance, Removing the oven door for cleaning, Warning – Avanti GR-24BG User Manual

Page 13

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

> operating Your Broiler Burner

The knob controlling the oven burner is also used for operating the

broiler burner. (See Figure 9) When the knob is turned in clockwise

direction, it controls the broiler.

When the knob is turned in the counter-clockwise direction, the oven is

engaged.

Those burners do not run simultaneously. The broiling burner has one

position. It is full on. The burner cannot be set to other heat outputs.

To operate the broiler burner;

Open oven door to confirm nothing is stored in oven cavity.

Place the heat deflector panel, as shown in Figure 11.

▲ WARNING©

If the heat deflector is not placed, the control
panel will overheat. This could damage the
control knobs, and creates risk of burn injury.

A

WARNING®

The maximum amount of weight placed on to the

oven shelf must not exceed 30 lbs.

Figure 11

Place food on a cold ungreased broiling pan and set rack to proper height.

Close the oven door, until it touches the heat deflector panel.

Push the oven knob forward. Ignition starts.

Turn it in the clockwise direction to BROIL position without releasing the knob.

Observe that the broiler burner is lit. Wait for ten seconds for the heating of flame failure
device, then release the knob.

Broiling does not require preheating.

All food should be turned at least once.

When the food is cooked enough, remove the food and turn the knob to ‘OFF’ position.

CARE AND MAINTENANCE

The appliance should be cleaned regularly for long-term operating.

Make sure that all parts of the range are cool before cleaning.

> Removing the Oven Door for Cleaning

Open the door fully.

There is a small ring on each hinge. Puli the ring over the

claw-like hook, which is part of the hinge mechanism. Do

not forget to do this on both hinges before the next step.
(See Figure 12)

Raise the door slightly and pull it straight out and away

from the oven. The door will come completely off.

Figure 12

When replacing the door, locate it back into the hinge holes.

Puli it down fully and slip the rings off the claw-like hooks.

Close the door and make sure that it sits in place fully. If not, repeat all above steps.

Advertising
This manual is related to the following products: