Adcom 2-CHANNEL GFA-5275 - Manual (Page 2)

IF YOU READ NOTHING ELSE,
PLEASE READ THIS PAGE:
<J> INSTALLATION ADVISORY: Be sure to
connect
the POWER{+) and GROUND{~) correctlyll
Amplifiers
that are incorrectly connected are
not
covered by the
warranty.
INSTALUTION ADVISORY: It is possible for
clipped strands of wire to eriter the amplifier through
the Free*Flow perforated sieOve. Be sure to dip wires
well away from the amplifier to avoid this possibility
<|> INSTALUTION ADVISORY:
The GFI‘5200
Balanced Line driver needs
to
be pieced as close to
the source unit as possible.
The complete "Balanced
Line System* will operate properly ONLY when the
GFl-5200 is installed correctly.
<5> OPERATION ADVISORY:
Make sure the two
sensitivity controls on the amplifiers are set fully
clockwise.
When matching the output of the source
unit with the input of the amplifier, adjust the level
controls on the
GFP5200
instead of the amplifier.
<|> OPERATION ADVISORY: Even though Adcom
amplifiers are capable of ddving very low Impedances,
it is recommended that the conUguradon not be lower
than 10 stereo, or 2^ Mono.
This will ensure that you
receive optimum power and control, lowest distortion
and greatest reliability.
<|> OPERATION ADVISORY: If you are using this
amplifier with a GFI-4600 crossover, then please see
the “Connecting the GFI-4600* section on page 8.