Audiovox AV-970 - Manual (Page 7)

CHEVROLET-OLDSMOBIIE-BUICK-POIfTIAC-GMC-CADILLAC-SJmiRNmSTALUTION
1982 AND NEWER
|mppft»nt-Thls in$tallation is designed lor most 1982 and newer GM cars, trucKs, and vans where an Installatior kit
is required. See Kit Listing on Page 2 of this manual or refer lo the in-store application chart. If a kit is not required,
use the irislnjclions on Page 5.
1, !!■■■— Eairtim ItaJt«
A. F amove the existing dashboard trimpanel surrourkding the radio opening. This panel is usually secured by
screws and/or snap-in clips.
B. Remove the screws used to secure the radio to Ihe sub-dashboard.
C Pull the radio forward to access the wiring and antenna cables plugged into the rear of the chassis.
D. Un-plug the wiring hamessfes) and antenna cable and remove the radio.
i 2. mt>l(№«NHrlMi«
A. Follow the instructions included wHh the installation kil to attach the radio to the mounting plate supplied with
I the kit.
B. Place the radio near Ihe dashboard so the wires can be led through the opening and following the instructions
of Stepson Page 5. carefully wire the radio making certain all connections are secure and insulated and confirm
proper operation.
Q. Install the radio/lmountLng plate assembly to the sub-dashtxiard accoiiding to instructions of inslallaiion kit.
D. Attach one end of the perforated support strap (supplied) to the screw stud on Uie radio using the hex nut
provided. Fasten the other end ol the perforated strap to a secure part of the dashboard either above or below
the radio using the screw and nut provided. Bend Ihe strap lo position it as necessary.
CALfTlONt The rear oí the radio must be supported with the strap to prevent damage lo the dashboard from the
weight ol the radio or improper operation of the radio due to vibration.
E. Replace the dashboard trimpanel.
F. Install knobs on radio shafts.
wm