AEG LAVAMAT 6450 - Manual (Page 35)

Your laundry has been washed at too low a temperature,
even afierre final rinse sequence (rinse-stop), foam is
still visible?
Modem detergents cause frothing even in the final rinse
water, which, however, has no effect whatever on the rinsing
result,
conditioner flecks remain on the finished iaundry?
This is in most cases likely to be due to the fact that condition-
ihg rinse - especially that in concentrated form - has directly
affected your laundry.
Wash out these flecks as quickly as possible, and take care
when handling these agentsi
white detergent residues remain on the laundry after
tfie programme has ended?
These residues mostly refer to insoluble constituents of mod­
em detergents. They are not due e.g. to insufficient rins­
ing.
Possible remedies; Brush or shake out, or possibly also turn
garments inside out for washing. Check detergent selection,
no water can be seen In the port-hole?
Modem washing machines work very economically, with such
small quantities of water that .it is sometimes not visible
through the port-hcrie. Nevertheless, the machine still washes
and rinses perfectly.
the laundry is insufficiently spun or water remains in
tfie drum?
Owing to a kinked hose, tiie pump is delivering too little water
from your washing machine:
The pump head of max 1 metre has been exceeded. For such
cases, the service centre stocks a retrofitting kit with a second
pump.
The suds pump is choked,
Proceed'as foHows when cleaning the suds pump:
Unplug your washing machine or take out the fuse.
Drain the water from the machine as described under "Emer­
gency ernptying in the event of a power failure" in the next sec­
tion.
Unscrew the suds pump cover anticlockwise (see arrow) and
remove together with the insert, placing a cloth underneath
beforehand, since residual water may still run out.
35