AEG 1263 - Manual (Page 12)

Connection
Electrical
connection
Connection to
the mains
water supply
12
Details of the mains voltage, type of current and protection
required are given on the appliance rating plate which can be
found on the frame, after opening the porthole door.
WARNING: THIS APPLIANCE MUST BE EARTHED.
The manufacturer declines any liability should this safety
measure not be observed.
If the appliance is to be permanently connected to the power
supply you must install a circuit breaker with a gap of at least
3 mm between the contacts, which enables the appliance to
be completely isolated from the mains supply.
The mains supply cable must not be extended. If it is not long
enough, replace it with a new, longer cable or move the applian­
ce closer to the power socket.
Before connecting the hose be sure to fit the mesh filter
supplied.
The inlet hose must not be extended. If it is too short and you do
not wish to move the tap, replace it completely with a longer
high pressure hose specifically designed to solve problems of
this type.
The end of the hose connected to the back of the machine can
be turned in any direction. Simply slacken the connector fitting,
position the hose as required and fully tighten the connector to
avoid leakage of water.
NON-STOP operation can be used for
cottons
synthetics
It cannot be used for delicate fabrics and wool.
Warning: When using NON-STOP operation for washing plus
drying, it is essential to keep to the following maximum loads:
Cottons
Easy cares max. 3 kg
max. 2 kg
The drying time must be selected at the same time as the wash
programme.
The drying for cotton fabrics is carried out at full heating power,
for easy cares at reduced heating power.
If you wish to change the selected drying time during washing
turn the time selector knob clockwise to the required time.
Automatic
washing
and drying
(NON-STOP
operation)
33