Altec Lansing 3300A - Manual (Page 6)

Operating Instructions for the Altec Lansing 3300A Series Mixing Consoles
Figure 5. Output section controls.
freedom from clipping
distortion. If the fader must run
wide open to get enough, level,
turn up the TRIM control
judiciously or increzise the level
setting of the left and right
subgroup controls. Conversely,
if the fader must be pulled way
back to get the right level, the
TRIM
control or ;ereo
subgroup should be adjusted.
Adjust the TRIM control ii’ the
PEAK LED lights, otherwise ad­
just the stereo subgroups. For
optimum performance, the
channel FADERS should be run
close to the "0" mark.
4.2 Output Section Controls
(Refer to Figure 5.)
1. TO MON Send (AVX 1. AUK
2): The TO MON level control
determines the amount of exter­
nally generated effects signals
in the monitor mix. With the
use of this control, the
performers can hear the added
effects in their monitors.
2. Effects SEND (AUX1,AUX2):
The effects SEND control sets
the level of the signal appearing
at the effects send output
jack(s) going to any type of
outboard effects device(s) such
as a digital reverb. Hanger,
compressor/limiter,
etc. The
source of this signal is via the
individual AUX 1 and AUX 2
send level controls on each
input channel.
3. Effects RETURN (AUX 1,
AUX2): The effects RETURN
level control determines the
amount of externally generated
effects signals in the main mix.
This signal is mixed into the
left and right stereo sub
channels via the AUX 1 and
AUX 2 PAN control(s).
4. PAN Control (AUX 1, AUX
2): The effects PAN control
(AUX 1, AUX 2) directs the
signal coming from the effects
ALTEC LANSIN(f CORPORATION • a Mark IV Company