Install valve trim – American Standard Moments Bath / Shower Trim Kits T50.50X User Manual
Page 2
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
INSTALL VALVE TRIM
Figure "1. Remove plaster guard from valve. Push CAP (1J
over VALVE CARTRIDGE (2) until seated against stop.
Figure 2. Push ESCUTCHEON HOLDER (3) onto CAP (1)
and attach with LONG SCREWS I4J. Mount ESCUTCHEON
SUPPORT (5) to ESCUTCHEON HOLDER (3) with 4 SHORT
SCREWS (6).
Figure 3. Align PINS I7] on back side of ESCUTCHEON (8)
with the FOUR HOLES (9) in ESCUTCHEON SUPPORT [5)
and press ESCUTCHEON (8) flush against finished wall.
Figure 2.
INSTALL TUB SPOUT, SHOWER HEAO,
SHOWER ARM WITH FLANGE
CAUTION: Protect finish on SHOWER
HEAD and TUB SPOUT when instailing.
Remove pipe cap and plug from shower and tub
rough piping.
Install SPOUT ESCUTCHEON (1J onto TUB SPOUT (2).
Apply sealant or Teflon tape to threads of tub filler
nipple. Thread TUB SPOUT (2) onto tub nipple.
CAUTION: Protect finish on TUB SPOUT when
installing.
Install SHOWER ESCUTCHEON (3) onto SHOWER
ARM (4J. Apply sealant or Teflon tape to threads on
both ends of SHOWER ARM (4) and thread longer
leg of SHOWER ARM (4) into shower elbow.
Thread SHOWER HEAD (5) onto SHOWER ARM (4).
CAUTION: Protect finish on SHOWER HEAO and
ARM when installing.
SHR.
ELBOW
TUB FILLER
NIPPLE
M968951