Aiwa CT-ZI09 - Manual (Page 10)

TAPE PLAYBACK SOUND ADJUSTMENTS
Auto reverse function
When the end of the tape is reached during
piayback or fast tape transport, the direction of
the tape is automaticaiiy reversed, and piayback
starts again.
Tape transport side indications
The foilowing indications are dispiayed to sho\w
the currently playing side.
2 1
MUTE
Upper side Lower side
\p
►
Before turning the ignition off
Be sure to eject any cassette from the unit before
turning the ignition off.
Switching modes
When the unit is in Radio mode, inserting a
cassette switches the unit to Tape Play mode
automaticaiiy.
To prevent tape problems
Before inserting a cassette into the unit, make
sure that there is no slack in the tape. If necessary,
take up the slack by inserting a pencil into the
spindle hole and winding.
90-minute or longer tapes are extremely thin and
easily deformed or damaged. They are not
recommended.
Press SEL to select the mode that you
wish to adjust from: VOL (volume),
BASS (bass), TRE (treble), BAL
(balance) and FAD (fader).
The following indicators appear in cyclic order.
If you do not proceed with step 2 within 5
seconds, the selected mode is canceled, and
the indication returns to the current source
mode.
Press +/— to adjust the level.
Press and hold either button to change the
level rapidly.
— +
PZill
Decreases the
volume level
Increases the
volume level
Decreases the
bass level
Increases the
bass level
Decreases the
treble level
Increases the
treble level
Decreases the
level of the right
speaker(s)
Decreases the
level of the left
speaker(s)
Decreases the
level of the front
speakers
Decreases the
level of the rear
speakers
Without selecting any mode with SEL, only
the volume level can be adjusted by pressing
+/-.
MUTE button
Press this button to temporarily lower the volume.
Press it again to restore the previous volume.
9
ENGLISH