Avanti 310VFYWH - Manual (Page 9)

CHANGING REVERSIBLE DOOR
This réfrigéra lor has been buill with Ihe
door hinges on Ihe right. If you wish to
change the opening direction, bilow Ihe
instructions below.
1- Remove the upper plate (2) by
removing the closing pins and the
screws (1).
2- Remove the boUs (3) of Ihe upper
hinge. Carefully lift the door (4) and place
il on a padded surface to prevent
scratching.
3- Remove the lower hinge bolls (5) by
removing its bolts. In order to achieve
this procedure. lift your refrigerator to a
sufficient height from the front side by the
help of somebody.
4- Remove the adjustable leg (6) and fit
it to the other side (7).
5- Fit the lower hinge to the left
comer {8).
6- Set the door (9) to Its place making
sure the hinge pin enters the bushing in
the door bottom section,
7< While holding the door in the closed
position, loosely secure the upper hinge
(10) using the bolls removed in STEP 2.
8- Before tightening these bolts, make
sure the top of the door is level with the
cabinet lop. Avoid over-tighlening these
bolls. Tighten both until they are just
snug, then turn another one-half turn
9- Set the upper plate (11) to its place.
10- R1 the screws and the closing pins
(12) of the upper plate.
14