DoorKing 1820 - Manual (Page 37)

3.4 Entry Codes
Entry codes are a four digit number (preceded by #) than can be entered on the Doorman or lobby
telephone keypad to gain access through the door or gate. When a programmed entry code is
entered on the Doorman or lobby telephone keypad, the relay on the 1820 control panel will activate
for the programmed strike time. The maximum number of entry codes that can be stored in the 1816
memory is 10,000. Use the log sheet provided in the back of this manual to record your entries.
Skip this section if a DoorKing Lobby panel is used. Entry codes will be programmed directly into the
lobby panel memory, not the 1820 memory.
3.4.1 Programming Entry Codes
Entry codes can be any four digit combination.
Factory Default = (Not Programmed)
1. Take the doorman telephone off hook.
2. Press *02 and enter the four-digit MASTER CODE _ _ _ _ (beep).
3. Enter a four-digit entry code _ _ _ _ then press * (beep).
4. Repeat step 3 to enter additional entry codes.
5. Hang up the doorman telephone to end the programming session.
3.4.2 Erasing Individual Entry Codes
This sequence allows you to erase an individual entry code (or codes).
Factory Default = (Not Programmed)
1. Take the doorman telephone off hook.
2. Press *06 and enter the four-digit MASTER CODE _ _ _ _ (beep).
3. Enter the four-digit entry code to be erased _ _ _ _ then press * (beep).
4. Repeat step 3 to erase additional entry codes.
5. Hang up the doorman telephone to end the programming session.
3.4.3 Erasing All Entry Codes
This sequence will erase all entry codes that have been programmed into the system.
Factory Default = (Not Programmed)
1. Take the doorman telephone off hook.
2. Press *00 and enter the four-digit MASTER CODE _ _ _ _ (beep).
3. Enter 9 9 9 9 then press * (a long beeeeeep will be heard when complete – about 3
seconds).
4. Hang up the doorman telephone to end the programming session.
1820-065-B-2-06 Page 37