Luxman LR-8500 - Manual (Page 17)

- 17 -
Press the STANDBY/ON button.
Select a source by pressing the SOURCE (5/b) button
repeatedly.
DVD
CD
TUNER
TAPE
7.1 CH DIRECT IN
VIDEO 1
VIDEO 2
AUX 1
AUX 2
Press DIGITAL button and press the 5orb button
repeatedly to select one of the digital inputs or the ana-
log input for any source.
or
1. Press the MENU button on the front panel.
2. Each time the SELECT(5orb) button is pressed until
"DIGITAL INPUT" displayed on the front panel.
3. Press the ENTER button.
4. Each time the SELECT(5orb) button is pressed to
select you desired input.
Play the source, and gradually turn up the volume to
the required level with the VOLUME control. 4
3
2
1
Basic Operations 1
VOLUME SOURCE SELECT
MENU ENTER STANDBY/ON
DIGITAL
is connected to the ZONE II IR Input jack, this button
will raise or lower the volume in the remote room.
INPUT Selectors
When the LR-8500 is off, press one of these buttons to
select a specific input and turn the unit on. When the
unit is already in use, pressing one of these buttons
will change the input.
MUTE
When used in the room where the LR-8500 is located,
press this button to temporarily silence the unit. When
it is used in a remote room with a sensor that is con-
nected to the ZONE II IR Input jack, this button will
temporarily silence the feed to the remote room only.
Press the button again to return to the previous vol-
ume level.
TUN-M
Switches from tuning to (manual or auto) tuning mode.
NOTES:
• The ZONE II remote may be used in either the same room
where the LR-8500 is located, or it may be used in a sepa-
rate room with an optional infrared sensor that is con-
nected to the LR-8500's ZONE II IR Input jack. When it is
used in the same room as the LR-8500, it will control the
functions of the LR-8500 or any compatible LUXMAN
products in that room. When it is used in a separate room
via a sensor connected to the ZONE II IR Input jack, the
button for Power, Input Source, Volume and Mute will
control the source and volume for the second zone, as
connected to the ZONE II Audio Output jacks. (See page
30 for complete information on using the ZONE II sys-
tem.)
9
8
7
Control Functions
3