Acrosser AR-B5630 - Manual (Page 32)

Revision: 2.01
32
NOTE 1:
J12: Front panel connector.
When using AT mode in the system, the pin9-10 of header J12 must be shorted. If using ATX
mode in the system, the pin5-6 of header J12 should connect to a
Push-Button-Switch.
NOTE: When using AT mode, the monitor will not display any message and
the system will not auto-shut down after soft-off. In this case, please cut the
PSU’s power off or remove PSU’s power to cut the system power off.
STATUS SETTING
1, 2
External buzzer.
5: Buzz +
6: Buzz -
3, 4 Hardware reset
5, 6
Power button for ATX
mode; jumper shorted
for AT mode.