ADLINK PXIS-3320 - Manual (Page 22)

14 Installation
3.2 Installing the Chassis and Starting Up
Follow the steps to power on the chassis.
1. For rackmount or bench-top installation, provide a suffi-
cient space under the chassis for ventilation and make
sure that the chasis is installed on a flat and stable sur-
face.
2. Put the power switch in the standby (OFF) position. The
power switch protrudes from the bezel when the system
is in standby power mode. Refer to the illustration below.
The front-panel power switch turns the system ON or
OFF.
3. Plug the AC power cord to a properly grounded wall
socket or power strip.
4. Make sure that the CPU, memory modules, and storage
device are properly installed on the system controller
module.
5. Push down (loose) the ejector/injector handles of the
system controller module.
6. Align the system controller module’s top and bottom
edges to the card guides.
7. Carefully slide the system controller module into the
chassis, then push the ejector/injector handle up to
secure the module in place. Secure the module with
screws from the chassis front panel.
8. Install additional 6U PXI/CompactPCI peripheral mod-
ules, if needed.