ADLINK CT-61 - Manual (Page 80)

70 IPMI User Guide
OemRescanGaInput
This command is used to rescan the geo-address input pins and
reset the IPMB address according to the input value.
OemTestFunction
Internal test purposes only.
OemSetBlueLEDLongBlinking
This command is used to enable or disable the slow blink of the
blue HotSwap LED when a voltage is detected to be over ±5% out
of range for five seconds (see Table 4-1 on page 22).
This function
is set to enabled by default.
Action Byte Value Description
Request
0 C0h NetFn/LUN for OEM
1 22h OEM defined command
Response
0 Complete Code 00h means OK
1 New IPMB address New IPMB address value
Action Byte Value Description
Request
0 C0h NetFn/LUN for OEM
1 31h OEM defined command
2 00h or 01h
00h: disable slow blink capability
01h: enable slow blink capability
Response 0 Complete Code 00h means OK