3 getting started, 1 removing the chassis lid, 2 installing the cpu/heatsink – ADLINK CSA-5200 User Manual
Page 13: Removing the chassis lid, Installing the cpu/heatsink
Advertising
13
CSA-5200
3 Getting Started
3.1 Removing the Chassis Lid
1. Remove the four screws securing each side of the lid to the chassis.
2. Remove the two screws securing the rear of the lid to the chassis.
3. Slide the lid to the rear and remove from the chassis.
3.2 Installing the CPU/Heatsink
1. Locate the CPU sockets on the board.
2. Press the load lever, move it outwards until it is clear of the retention tab, then raise it
3. Open the load plate and remove the protective cover from the socket. Do not touch
the socket contacts or the bottom of the processor.
Advertising