ADLINK HPERC-IBR-HH - Manual (Page 29)

Internal Components 19
HPERC-IBR-H
2 Internal Components
This chapter discusses the optional components inside the HPERC-IBR-H enclosure. These
components include the SSDs (Solid State Drives), the SD Memory Card, the PCI/104-Express
expansion module, the SODIMM memory, and the Mini PCIe Card.
2.1 HPERC-IBR-H Assembly Procedures
The following procedures describe how to remove and install the HPERC-IBR-H internal compo-
nents. To gain access to certain components in the HPERC-IBR-H, you first must remove other
components in the system.
2.1.1 Tools Required
Use these tools to install and remove components into or out of the HPERC-IBR-H enclosure.
X Hex screwdriver set
X Anti-static service kit - Use a complete anti-static service kit (or the equivalent) to remove
or install static-sensitive components. A complete anti-static service kit should include a
static-dissipating work surface, a chassis clip lead, and a wrist or ankle strap.
2.1.2 Shutting Down the HPERC-IBR-H
Always use the following procedure when shutting down the HPERC-IBR-H.
To shut down the HPERC-IBR-H
1) Initiate a shut down sequence through the OS, or hold down the power button on the
corresponding military breakout cable for 4-6 seconds to turn off power.
2) Disconnect the power cable from the DC Power IN connector of the I/O panel.
NOTE: Some of the figures in this chapter show only the heat sink version of the HPERC-IBR-H
because the procedure described is the same for both versions. For clarity, the figures in this chapter
may not show some of the cables or components.
CAUTION: Components in the HPERC-IBR-H are sensitive to static electricity and can be easily
damaged by improper handling. Do the following when handling the HPERC-IBR-H.
Always use an anti-static wrist/ankle strap and a grounding mat.
Before you handle the HPERC-IBR-H, touch a grounded, unpainted metal surface to discharge any
static electricity.