ADLINK HPERC-IBR-HH - Manual (Page 30)

20 Internal Components
2.1.3 Replacing the SSDs (Solid State Drives)
The SSD slots are two of three externally accessible component slots on the enclosure. The
other externally accessible component slot is the SD memory card slot. SSDs allow you to
install an OS and store data for the system.
To remove the SSDs (if installed) from the enclosure side panel
1) Shut down the system as described earlier in Shutting Down the HPERC-IBR-H.
2) Remove the screws mounting the SSD cover plate as shown in Figure 2-7.
3) Remove the SSDs from their slots using the plastic tabs on each drive.
Figure 2-7: Exploded View of HPERC-IBR-H with SSDs
To install the SSDs into the enclosure side panel
1) Insert SSDs into their slots as shown in Figure 2-7, ensuring to seat the drives fully on their
connectors.
2) Install the SSD cover plate using the screws provided. Ensure that the cover plate properly
aligns with the gaskets on the slots.
SSDs
SSD Cover Plate SSD Cover Plate SSD Cover Plate
SSDs SSDs
SSD Gasket