ADLINK Food-D19 IP69k - Manual (Page 13)

Document:
Manual_Giant_Food_Series.docx Page 13 of 47 pages Last change date: 25-Oct-11
7. BIOS
CONFIGURATION OVERVIEW
This chapter provides information about necessary BIOS settings. These settings have been carefully
tested by PENTA and are recommended for proper operation.
On any problems please restore the default BIOS settings first by pressing <F9> key, then change the
different values to the one as documented below.
Default BIOS settings are marked as “Default”.
7.1. Introduction
The Bios is programmed onto the BIOS chip. The BIOS setup program allows changes to certain
system settings.
7.1.1. Starting Setup
The American Megatrends, Inc. (AMI) BIOS is activated when the computer is turned on. The setup
can be started in one of two ways.
•
Press the DEL key as soon as the system is turned on or
•
Press the DEL key when the “Press DEL to enter Setup” message is shown on the screen
If the message disappears before the DEL key is pressed, restart the system by pressing
CTRL+ALT+DEL and try again.
7.1.2. Using Setup
Use the arrow keys to highlight items, press Enter to select, use + and - to change entries, press F1
for help and ESC to quit.
Key
Function
Up arrow Move to previous item
Down arrow Move to next item
Left arrow Move to the item on the left hand side
Right arrow Move to the item on the right hand side
Esc
Main Menu – Quit and not save changes into CMOS
Status Page Setup Menu and Option Page Setup Menu – Exit
current page and return to Main Menu
F1 General help
F2 Load previous values
F3 Load optimized defaults (AMI default settings)
F4 Save all the CMOS changes and exit
+/- Change Option directly
7.1.3. Getting help
When F1 is pressed a small help window describing the appropriate keys to use and the possible
selections for the highlighted item appears. To exit the Help Window press Esc or the F1 key again.