Advanced Control Technologies Specs Instructions ZRW100I (RF 120 VAC, 15A, Feed ThroughWall Switch, Ivory) - Manual (Page 2)

ZRW100 Instructions
110503 HomePro
by ADVANCED CONTROL TECHNOLOGIES, INC.
0618-01
2
Child Protection
The Wall Mounted Switch can be set in a child protect mode by the Wireless Controller. When this mode is active,
a user will have to press the Wall Mounted Switch 3 times rapidly to activate the attached load. The module
operates normally when controlled by the Wireless Controller..
Other functions
The paddle on the Wall Mounted Switch also plays a role as a reset in addition to adding module to groups and
scenes. This is described in more detail in the Wireless Controller instructions.
Over-current protection
The Wall Mounted Switch is protected by an internal fuse. This internal fuse is factory serviceable only. Check
your home circuit breakers before concluding that the product must be returned to manufacturer for repair at a
nominal charge.
WARRANTY
For warranty and general product information visit our web site at www.act-solutions.com
ABOUT ZRW100’S CERTIFICATION
The ZRW100 has been thoroughly tested by the ETL SEMCO
division of Intertek, a nationally recognized testing laboratory. This
product was found to be in compliance with safety standards
ANSI/UL STD 244A and CAN/CSA C22.2 No. 177.
In addition to compliance with product safety standards, the ZRW100
is also certified to comply with applicable FCC and IC rules and
regulations governing RF and EMI emissions.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) This device must accept any interference received, including interference that may
cause undesired operation.
FCC NOTICE
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interfer-
ence to radio or television reception, which can be determined by turning the equipment off and on, the user is encour-
aged to try to correct the interference by one or more of the following measures:
- Increase the separation between the equipment and receiver.
- Consult the dealer or an experienced radio/TV technician for help.
IC NOTICE
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
Power 120 VAC, 60 Hz
Signal (Frequency) 908.42 MHz
Maximum Load Resistive: 15 amps (1800 watts) maximum, 120 VAC
Motor: 1/2 H.P. maximum, 120 VAC
Incandescent: 600W maximum, 120 VAC
Range Up to 100 feet line of sight between the Wireless Controller and /or the
closest HomePro Reciever Module