Advanced Control Technologies Specs Instructions ZRW153I (RF 120 VAC, 15A, Feed ThroughWall Switch, Three Way, Ivory) - Manual (Page 2)

ZRW153 Instructions, Release 1.1
P/D 103106 HomePro
by ADVANCED CONTROL TECHNOLOGIES, INC.
0706-01
2
BASIC OPERATION
(Local Control)
The switch paddle on the ZRW153 allows the user to:
• Turn on or off the attached load .
• Include or exclude the module from the Z-Wave system
• Control other Z-Wave enabled devices.
Also, when a controller prompts you to “Send Node ID” or to “Press Button on Unit”, quickly tap the switch on or
off once to satisfy those instructions. Also, quickly tapping on or off 4 times will give you the same result without
changing the state of the load attached or transmitting to other Z-Wave devices.
• Tapping top of switch turns the load attached ON.
• Tapping bottom of switch turns the load attached OFF.
• Pressing and holding switch does not effect the load attached but will allow dimming and brightening of Z-
Wave dimmers if associated (see below for details).
LED indication
The LED on the ZRW153 will turn on when the load attached is ON. The LED is user configured however to turn
ON when the load attached is OFF, if so desired, to act as a night light.
The ZDW103 will flicker its LED when it is transmitting to any of its 4 groups. This can be changed if desired.
Auxiliary Switch
The ZRW153 supports the AS101 auxiliary switch
Remote Control
The ZRW153 will respond to BASIC and BINARY commands that are part of the Z-Wave system. Refer to your
controller’s instructions as to whether your controller can transmit those commands.
See the information in the section titled Version for a complete list of commands the ZRW153 will support.
ADVANCED OPERATION
All On/All Off
The ZRW153 supports the ALL ON/ ALL OFF commands.
The ZRW153 can be set to respond to ALL ON and ALL OFF commands 4 different ways.
Refer to your controller for information on how to set the ZRW153 to operate in the manner you desire. Some
controllers may be only able to set certain settings of ALL ON/ALL OFF response.
The 4 different ways the ZRW153 can be setup to respond to ALL ON and ALL OFF commands are:
1. ZRW153 will not respond to ALL ON or the ALL OFF command.
2. ZRW153 will respond to ALL OFF command but will not respond to ALL ON command.
3. ZRW153 will respond to ALL ON command but will not respond to ALL OFF command.
4. ZRW153 will respond to ALL ON and the ALL OFF command.
Association
The ZRW153 supports the Association command.
The ZRW153 can be set to control other Z-Wave devices. You can turn on and off, and even dim other Z-Wave
devices once they are “associated” into 1 of 4 groups within the ZRW153.
Each group is turned on or off (or dimmed) by tapping or holding the switch a differing amount of times.
If you associate a Z-Wave device into Group 1, you can turn that device on and off by tapping the switch on or
off once. You can brighten or dim devices by holding down the switch in the on or off position. The load attached
to the ZRW153 will also turn on or off. Associating nodes into group 2 or 3 will cause a very slight delay before
the command is transmitted to group 1 nodes.
If you associate a Z-Wave device into Group 2, you can turn that device on and off by tapping the switch on or
off twice. You can brighten or dim devices by tapping the switch on or off once and then holding the switch down.