Advanced Control Technologies Specs Instructions ZTW100W (RF 120 VAC, Wall Transmitter,908.42MHz, White) - Manual

ZTW100 Instructions
P/D 050205
HomePro
by ADVANCED CONTROL TECHNOLOGIES, INC.
0690-01
1
Radio Frequency Controlled, 120 VAC,
Wall Mounted Transmitter
ZTW100
HomePro
RF Home Automation
Decorator trim plate included
ZTW100 WALL MOUNTED TRANSMITTER
The ZTW100 Wall Mounted Transmitter is a component of the HomePro lighting control system. Install the ZTW100
Wall Mounted Transmitter like a standard wall switch (it does not wire to a load) and program it from a Controller to
operate loads. Inclusion of this Wall Mounted Transmitter on a Controller menu allows programming of the ZTW100
to provide remote control of ON/OFF and DIM/BRIGHT of lamps connected to Z-Wave devices (or nodes).
This Wall Mounted Transmitter is designed to work with HomePro and other Z-Wave controlled lamp and appliance
devices. As part of a HomePro network, the ZTW100 will also act as a wireless repeater to insure that commands
intended for another device in the network are received. This is useful when the device would otherwise be out of
the radio range of the controller.
There are no field repairable assemblies on this unit. If service is needed, the unit must be returned where purchased.
DANGER! SHOCK HAZARD. Read and understand these instructions before installing. This device is intended for
installation in accordance with the National Electric code and local regulations in the United States, or the Canadian
Electrical Code and local regulations in Canada. It is recommended that a qualified electrician perform this installation.
For indoor use only. Retain these instructions for future use.
INSTALLATION
Wire this Wall Mounted Transmitter similar to a wall switch according to the diagram above. Refer to your Controller
operating instructions for instructions on how to add this module to the RF network.
Adding Transmitter to Network
1. Setup the Controller you are using to add the ZTW100 Wall Mounted Transmitter to the network, to a state
where it will be ready to include a Z-Wave device.
2. Tap either the top or bottom of the switch paddle on the ZTW100 4 times rapidly.
3. You should see an indication on your Controller that the “device” (ZTW100) was added to the network.
Note: On some Controllers you may see “DEVICE NOT SUPPORTED”. This means that you cannot
control the device (ZTW100) with the Controller, however the device has been added to the network.
This Wall Mounted Transmitter controls no load itself, but communicates with HomePro modules (or other
Z-Wave enabled devices) to turn a load ON or OFF and DIM or BRIGHTEN a lamp.