American Energy Systems BC7000 Auger Housing - Manual (Page 6)

F:\AESBusinessSystems\AES Technical\Piece part instructions\BC7000 Auger Housing
Assembly.doc
• Set the back panel so it is flush with the edge of the base.
• Attach the back panel to the main body with P003053 screws.
• Insert the P003230 AC inlet connector into the cutout in the back panel.
• Select the damper rod, the collar, the damper
spring, and the circular metal plate required
for installing the air intake damper assembly.
• Slide collar over shaft and do not tighten.
• Slide Damper Spring over shaft.
• Slide the damper plate into the 3” air intake tube.
• Set the collar so there is 12 +/-2mm space between
the collar and the bend in the rod as shown.
• Insert shaft with spring and collar attached into the
hole on the right side of the 3” tube, through the
mount on the circular metal plate, and into the hole
on the left side of the 3” tube.
AC inlet connector
!!Make sure the
white wires are on
the right side as
shown here