Angelcare AC701 - Manual (Page 10)

DEFAULT SETTINGS
YOU ARE NOW READY
TO USE YOUR MONITOR
The Angelcare ® monitor can be used with the pre-program factory settings
or you can also customize your settings to your preference.
IMPORTANT
• Test your monitor before first use.
• Test your monitor regularly to ensure it is functioning correctly.
• Test your monitor every time you move the Sensor Pad to a different place.
Sound Mode: ON
Speaker Volume: Level 3 (of 5)
Movement Mode: ON
Sensor Pad Sensitivity: Level 3 (of 5)
TIC: OFF
Temperature Alarm: OFF
Temperature Alarm Settings:
High Temperature Limit*:
30 °C
Low Temperature Limit*: 19 °C
VOX Mode: OFF
VOX Level: Level 2 (of 4)
ECO Mode: OFF
Alarm Mode: Sound alarm only
* High/Low Temperature Setting
preset values might be different
for various countries.
NOTE:
By doing the re-connection procedure you will reset
the monitoring system back to original presets.
STEP 6 - ACTIVATING AND DEACTIVATING ADDITIONAL FUNCTIONS
The Angelcare ® monitor is multifunctional. It can be use in different combinations
according to your needs.
MOVEMENT ONLY:
Allows you to detect the baby’s MOVEMENT ONLY
without the Parent Unit. This combination can be useful
when the baby is in the same room as the parents.
SOUND & MOVEMENT:
Allows you to detect the baby’s
MOVEMENT & SOUND while using both
Parent Unit and Sensor Pad.
SOUND ONLY:
Allows you to detect the baby’s SOUND ONLY without
the Sensor Pad. This combination can be useful if you
don’t want to use the Sensor Pad or if your baby is older
than 24 months (maximum age to use the Sensor Pad).
MULTIFUNCTIONAL
1
1
2
2
Slide the Nursery Unit Connecting switch
to 2 to detect MOVEMENT ONLY. If the
Parent Unit is turned on, the Parent Unit
will only display the Out-of-Range icon.
Slide the Nursery Unit Connecting switch to 1
to detect sound ONLY (Sensor Pad function
needs to be deactivated on the Parent Unit then
unplugged from the Nursery Unit).
Slide the Nursery Unit Connecting
switch to 1 to detect sound
and movement.
NOTE:
To safely store just make sure to remove the Sensor Pad and cords
from the crib – disconnect sensor cord plug from the nursery unit
and safely store away in box for future use.
The Angelcare ® monitor can be used with the pre-program factory settings
or you can also customize your settings to your preference.
IMPORTANT
When in settings mode, the sound
transmission between the Parent
and Nursery Unit will be temporarily
deactivated. ONLY the movement
alarm will remain active
(if function is already activated). NOTE:
All changes and adjustments
made in the
settings mode
will not be activated unless
you confirm them by pressing
the
Return icon.A long beep
will confirm your modification.
1 2
19 18