Angelcare AC701 User Manual
Page 13
TO STOP THE PAGING SOUND:
Press the Parent
Unit screen
or any buttons
Press the Nursery
Unit’s Page button
OR
OR
6.6 - MUTE
Allows you to activate the MUTE function.
TO ACTIVATE MUTE:
Press the Sound Icon.
TO DEACTIVATE MUTE:
Press the Sound Icon to deactivate.
NOTE:
The MUTE icon will blink
on the Parent Unit.
NOTE:
The Night Light function will be disabled
if the Nursery Unit is in battery mode.
OFF
Low
High
ON
OFF
6.7 - NIGHT LIGHT
Allows you to use your monitor as a night light.
TO ACTIVATE THE LIGHT:
Push the
right ‘wing’ of the Nursery Unit or press
the
Night Light icon on the Parent Unit to select
light level.
6.8 - PAGER
Allows you to locate the Parent Unit.
TO LOCATE PARENT UNIT:
Press and release the Nursery Unit Pager button.
The Parent Unit will emit a paging sound
for one minute.
NOTE:
Make sure the Nursery
Unit Connecting switch
on the back of the unit
is in the position 1.
TROUBLESHOOTING
3
4
Re-connection procedure:
1) Turn on the Parent Unit and hold the
Talk button down for 2 seconds until
the Nursery Unit icon shows at the
center of the screen.
2) By pressing the Nursery Unit Icon
button the Parent Unit will be set in
to connectivity mode (the icon will
flash).
After 1 minute of non-operation, the Parent
Unit will exit the connectivity mode and you
will need to start this process again.
3) Press the Power button to turn on
the Nursery Unit. The Power LED
will light.
4) Then press the Power button 4 times
within 30 seconds. The Power LED will
blink. The connection procedure should
be completed within 10 seconds.
5) When the Parent Unit and Nursery
Unit are connected, H1 (or H2)
will be displayed on the Parent Unit
and then be followed by the normal
mode screen.
1
2
5
NOTE:
By doing the re-connection procedure you
will reset the monitoring system back to
original presets.
LOSS OF CONNECTIVITY
In the case of loss of connectivity, the first step is to bring the Parent Unit and Nursery Unit
closer together and make sure that both units are ON to restore the connection. If there is
still no connection and no out of range warning after the above has been done, then and
only then should the re-connection procedure below be done.
TAKING CARE OF YOUR RECHARGEABLE BATTERIES
• Ensure that you fully charge your batteries for 15 hours before their first use.
• To maintain maximum battery life it is recommended that you fully discharge
your batteries periodically. Battery performance can be diminished by leaving
the batteries constantly charging on the charging cradle. If your parent unit is not
in use, please turn it off.
• Inadequate battery power can impair the performance of your monitor. If you are not
happy with the performance of your Parent Unit/Monitor please replace the
rechargeable batteries (2 x NiMH Rechargeable Batteries).
• It is advisable to change the batteries every 6 months.
1
2
25
24