ANSMANN 5102133 AS 10Hplus User Manual
Page 5
cApAcity diSpLAy:
When operating the portable search light, the battery capacity available will be signaled through
1 DUO light-diodes:
1 GREEN LED:
100 %
1 RED LED:
< 25 %
1 blinking LED: When the remaining battery capacity is reached, it is possible to switch over to the energy spar-
ing lamp (remaining light duration > 2 h)
repAir And mAintenAnce:
Repair work may only be performed by professionally trained electricians!
Only original replacement parts may be used!
Used batteries should be delivered to recycling, and do not belong with the household garbage!
conStruction of tHe SeArcH LigHt:
1. Battery capacity display through 1 DUO LED.
2. Operation selection control switch.
3. Charge socket Input 12 V - 24 V.
4. Wall bracket.
5. Search light head with halogen lamp.
6. Energy saving lamp with 4 high performance LEDs on the underside of the portable search light.
7. Housing with integrated lamp control system and charging electronics.
wHen cHAnging tHe LAmp, pLeASe proceed AS foLLowS:
> Open the lamp rings by pressing the switch on the lamp head upper side
> Carefully remove the lamp ring with the reflector
> Cautiously remove the lamp, forwards
> Grasp the new lamp with cloth, and insert it into the prescribed opening
> Install the reflector; all the while pay careful attention that the opening of the given lamp is mounted in his correct
position
> When closing the lamp ring, pay careful attention that the switch has been correctly applied, and that it is pressed
until it stops.