ANSMANN 5311123 APS1500 traveller User Manual
Page 9
4.) SEt VoLtAGE FoR thE EqUIPmENt / oPERAtIoN
check the voltage (V) required for the equipment to be powered. Set the
required voltage with the rotary switch [6] by using the key [5] and connect
the power supply to the mains once the equipment to be powered has been
connected. If you do not know the required voltage, start with the lowest
voltage and gradually increase it until the connected device works. In this
case no claim for damage can be accepted, as ideally the correct voltage
should be set according to the equipment’s instructions.
WARRAnty nOtICE
We hereby offer a 3 year warranty on this power supply. this does not apply
to damage caused by improper handling (e.g. incorrectly set polarity or
voltage). ANSmANN cannot accept liability for direct, indirect, accidental or
other claims or consequential damages originated by not using this device
as indicated by these operating instructions.
technical details subject to change without prior notice. No liability
accepted for typographical errors or omissions. 09/2010