Austin Hughes Automatic Transfer Switch - Manual (Page 5)

UM-IP-ATS-Q215V1 www.austin-hughes.com
< 1.3 > Installation
Don’t exceed the outlet, branch or phase limitations
All electrical power and power control wiring must be installed by a qualifi ed electrician
and comply with local and national regulations.
■
It is very important to mount the equipment in a suitable cabinet or on a stable surface.
■
Make sure the place has a good ventilation, is out of direct sunlight, away from sources of excessive
dust, dirt, heat, water, moisture and vibration.
Before Installation
Use the provided screws to attach the mounting bracket set
( set of 3 ).
Step 1
1
M6
screw
Use the M6 screw set to secure the ATS to your rack
( M6 screws not provided ).
Step 2
2
Cable
tie
Use the cable ties to fasten each power cord to the
cord retention tray ( cable ties not provided ).
Step 3
3
P.3