Bonaire Cool Change (Newtronics) - Manual (Page 11)

Integra
Owner’s Manual
Page 11
Power Supply Interruption
•
The unit will not operate if power supply is interrupted (due to supply failure). In such a
case it is possible that the display will still indicate the air conditioner is operating.
•
When power is restored the air conditioner will be in the OFF mode.
•
To regain full control of your air conditioner press any button on the hand held Comfort
Controller. Your air conditioner will commence operation on the settings indicated on the
display
CONFIGURING YOUR COMFORT CONTROL
The "pre-cool start" feature has to be configured before you operate your air conditioner. This
feature may never need to be altered if you are happy with the factory settings.
PRE-COOL STARTS
Your Comfort Controller is supplied with "pre-cool start" disabled. The "pre-cool start" features
ensures the filter pads are wet prior to starting the fan. This means that after starting your air
conditioner there may be a delay of up to 3 minutes before the fan starts. During a "pre-cool
start" cycle the word "PRE-COOL" flash.
•
In manual or economy mode operation, if you have recently run your air conditioner on
cooling or you start your air conditioner on "FRESH" there will not be a "pre-cool start"
cycle.
•
In automatic mode operation, if you start your air conditioner on "COOL" or "FRESH",
there will be a "pre-cool start" cycle.
To enable the "PRE-COOL START feature:
1. Turn on the comfort controller
2. Simultaneously hold down the COOL and PAD CLEAN buttons for 5 seconds
3. The words "PRE-COOL" and START will flash when you have enabled "PRE-COOL
START".
To disable the "PRE-COOL START feature:
turn on the comfort controller simultaneously hold down the COOL and PAD CLEAN buttons
for 5 seconds The words "PRE-COOL" and "STOP" will flash when you have disabled
"PRE-COOL START