Cino L780BT HC - Manual (Page 3)

2
Preparations before Using
Install the Battery
Charge the Battery
Use USB Bus Power
Choose an appropriate plug and slot it into the
power adapter cavity until it is locked. Then plug
the AC power plug into the AC wall socket.
Plug the DC power cord of power supply unit
into the DC Jack of the cradle. The smart cradle
emits the power-on beeps and the central
indicator gives one blue blink. If you use the
charging cradle, the central power indicator
turns steady blue.
Place the scanner on the cradle. The status
indicator of scanner turns steady red if the
battery is not fully charged. When the battery is
fully charged, the status indicator of scanner
turns steady green.
Please charge the new battery pack for 8 hours
before its first use.
Ensure the battery contacts of the battery pack
are facing the charging contacts inside
the battery cavity.
Slide the battery pack into the battery cavity until
hearing a click sound before locking it with the
end cap. The scanner will give 4 beeps when the
battery pack is installed properly if the battery
pack still has power.
Secure the end cap with the screw provided.
If USB 3.0 is available in your host device, both
battery charging and regular operation can be
supported by the USB Bus Power without using
external power supply.
If only USB 2.0 is available in your host device,
we recommend using external power supply as
power source, because the power supplied from
USB2.0 is not enough to support both battery
charging and regular operation simultaneously.
If you want to use this feature, please slide the
USB bus power switch to “ON”. Then connect
the cradle to the host device via USB cable.