Clay Paky ALPHA WASH 1500 - Manual (Page 22)

22 ALPHA WASH 1500
Fans
Monitor
Fan Speed (RPM)
Pwr.Sup XXXX
Ball.In. XXXX
Ball.Out XXXX
Eff.In XXXX
Eff.Out XXXX
Lamp XXXX
Network
params
SISTEM VERSION
Used for displaying the software and hardware version of each board
installed in the projector.
CPU brd (CPU board)
0: PT-3f (Pan / Tilt board)
1: 8-Ch (8 channel board)
2: 6-Ch (6 channel board)
BOARD DIAGNOSTIC
Used for displaying the status error of each board installed in the projector:
0: PT-3f (Pan / Tilt board)
1: 8-Ch (8 channel board)
2: 6-Ch (6 channel board)
DMX MONITOR
Used for displaying the projector DMX channel level in bit (Val) and in
percentage (Perc).
FANS MONITOR
Used for displaying the speed of each fan installed in the projector:
Pwr.Sup (Power supply Fan)
Ball. IN (Ballast IN Fan)
Ball. Out (Ballast OUT Fan)
Eff.IN (Effects IN Fan)
Eff.OUT (Effects OUT Fan)
Lamp (Lamp Fan)
SENSOR STATUS
It lets you check the correct operations of each "sensor” installed in the
projector, each channel is associated with one of the following three
parameters:
• n.a.= sensor not available
• ON= sensor working
• OFF= sensor defective
NETWORK PARAMS
Allows the "Network" parameters of the projector to be displayed or:
IP address: Internet Protocol address (two projectors must not have the
same IP address)
IP mask: 255.0.0.0
Mac address: Media Access Control: the projector’s Ethernet Address.
LAMP
Used for turning lamp on and off from the projector control panel.
1) Press
F - the current settings appear on the display (On or Off).
2) Use the UP B and DOWN C keys to turn the lamp on (On) or off (Off)
3) Press F to confirm the selection or LEFT D to keep current settings
and return to the top level.
RESET
Used for resetting the projector.
1) Press
F to reset the projectors, a confirmation message (Are you sure?)
appears on the display.
2) Select YES to starting reset the fixture or NO to keep the current setting
and return to the top menu level.
CHANNEL
Used for setting channel levels from the projector control panel.
1) Press
F - the first channel appears on the display.
2) Use the UP B and DOWN C keys to select the required channel:
3) Press F and use the UP B and DOWN C keys to select the
required DMX level (value between 0 and 255).
4) Press LEFT D to return to the top menu level.
MANUAL CONTROL
Dmx
Monitor
Lamp
Manual
Control
On
Off
No
Yes
Reset
Channel
Sensor
Status
System
Version Board Revis. Hw.rv.
CPU brd x.x.x x.x
com.dev x.x
0: PT-3f x.x x.x
1: 8-Ch x.x x.x
2: 6-Ch x.x x.x
Board
Diagnost.
Board Status Err%
0:PT-3f Good 0.00
1:8-Ch Good 0.00
2:6-Ch Good 0.00
Information