Clay Paky IGLOO ECO - C61196 - Manual (Page 2)

2 IGLOO
• Installation
Make sure all parts for fixing the equipment are in a good state of repair.
Make sure the point of anchorage is stable before positioning the equipment.
The safety chain must be properly hooked onto the fitting and secured to the framework, so that, if
the primary support system fails, the fitting falls as little as possible.
If the safety chain gets used, it needs to be replaced with a genuine spare.
• Minimum distance of illuminated objects
Carefully read this instruction manual dedicated to the projector inside the IGLOO.
• Minimum distance from flammable materials
Carefully read this instruction manual dedicated to the projector inside the IGLOO.
• Maximun / Minimum environment temperature
Do not use the device if ambient temperature (Ta) exceeds: see details on page 3.
The minimum permissible ambient temperature of use is -20 ° C.
When the environment temperature falls below 0 ° C, it is necessary to switch-on projector and lamp
located inside the Igloo, at least 30 minutes before use, so as to lead to thermal regime the fixture
effects.
• IP54 protection rating
Igloo is protected against dust (first digit 5) and splash (second digit 4).
• Protection against electrical shock
Connection must be made to a power supply system fitted with efficient earthing (Class I appliance
according to standard EN 60598-1).
It is, moreover, recommended to protect the supply lines of the equipment from indirect contact
and/or shorting to earth by using appropriately sized residual current devices.
• Connection to mains supply
Connection to the electricity mains must be carried out by a qualified electrical installer.
Check that the mains frequency and voltage correspond to those for which the equipment is
designed as given on the electrical data label.
This label also gives the input power to which you need to refer to evaluate the maximum number
of fittings to connect to the electricity line, in order to avoid overloading.
• Temperature of the external surface
The maximum temperature that can be reached on the external surface of the Igloo, in a thermally
steady state, is 90°C (194°F).
• Maintenance
Before starting any maintenance work or cleaning the device, cut off power from the mains supply.
Carefully read the projector's instruction manual for maintenance of the projector inside the igloo.
Replace any damaged part with original ones.
This product is intended for the following areas of application:
studios, stages, theaters, exhibitions, trade fairs, events, theme parks, entertainment venues,
architectural lighting and similar
Not suitable for household illumination
Not for residential use
Disposing
This product is supplied in compliance with European Directive 2012/19/EU - Waste Electrical and
Electronic Equipment (WEEE). To preserve the environment please dispose/recycle this product at
the end of its life according to the local regulation.
SAFETY INFORMATION
The products to which this manual refers comply with the European Directives pursuant to:
• 2006/95/EC - Safety of electrical equipment supplied at low voltage (LVD)
• 199/5/EC – Requirements for radio equipment (R&TTE)
• 2011/65/EU - Restriction of the use of certain hazardous substances (RoHS)
• 2009/125/EC - EcoDesign requirements for Energy-related Products (ErP)
90°C
IP54
EN